OSHA requirements are set by statute, standards and regulations. Our interpretation letters explain these requirements and how they apply to particular circumstances, but they cannot create additional employer obligations. This letter constitutes OSHA's interpretation of the requirements discussed. Note that our enforcement guidance may be affected by changes to OSHA rules. Also, from time to time we update our guidance in response to new information. To keep apprised of such developments, you can consult OSHA's website at http://www.osha.govMarch 17, 2017MEMORANDUM FORREGION ADMINISTRATORSTHROUGHDOROTHY DOUGHERTYDeputy Assistant SecretaryFROM:THOMAS GALASSI, DirectorDirectorate of Enforcement ProgramsSUBJECT:Exemption of Variable Boom Reach Equipment (â¿¿Reach Stackersâ¿�) from the 29 CFR 1917.50 Certification Requirement for Marine TerminalsPURPOSE:This memo is to inform all Occupational Safety and Health Administration (OSHA) Field Offices that reach stackers are exempt from complying with the certification requirement set forth in 29 CFR 1917.50. BACKGROUND:On August 9, 2016, during the meeting of the Longshoring Workgroup, of the Maritime Advisory Committee on Occupational Safety and Health (MACOSH) and at a follow-up conference call on September 22, 2016, industry representatives expressed concern about OSHAâ¿¿s consideration requiring that reach stackers (Figure 1), be certificated pursuant to 29 CFR 1917.50. That provision requires certain material handling devices used in marine terminals, listed in paragraph (c), be certificated. However, there are exceptions to this provision. 29 CFR 1917.50(j)(1) provides that the certification requirement does not apply to: â¿¿1) Small industrial crane trucks as described on page 8 and illustrated on page 13 of ASME B56.1, 1959, â¿¿Safety Code for Powered Industrial Trucksâ¿¿, and powered industrial trucks.â¿� For the following reasons we conclude that reach stackers are powered industrial trucks and therefore fall within this exception. ASME B56.1, 1959, â¿¿Safety Code for Powered Industrial Trucks,â¿� p. 7, referred to in subparagraph (j)(1), defines a â¿¿powered industrial truckâ¿� as â¿¿a mobile, power-driven truck or tractor, as specifically defined below, used to carry, push, pull, lift, stack or tier material.â¿� A reach stacker is a mobile, power-driven truck, which moves loads both vertically and horizontally, used to handle and stack material. Therefore, a reach stacker is a powered industrial truck and thus falls within the subparagraph (j)(1) exception to the certification requirement of 29 CFR 1917.50. Furthermore, manufacturers of reach stackers have classified reach stackers as powered industrial trucks, just as they and OSHA classified top loaders (see Figure 2), which also stack materials, albeit only vertically. Thus, a plain reading of 29 CFR 1917.50(j)(1)) indicates that reach stackers used in marine terminals to load, unload, and move maritime cargo are exempt from the 29 CFR 1917.50 certification requirement because they are powered industrial trucks. However, powered industrial trucks used at marine terminals are subject to 29 CFR 1917.43 and to the powered industrial truck training requirements in 29 CFR 1910.178(l), as referenced in 29 CFR 1917.1(a)(1)(xiv). If you have any questions, please contact Nicholas DeAngelis in the Office of Maritime Enforcement at [email protected] or 202-693-2186.