QR Code Link to This Post This is a homemade hydraulic motorcycle lift I built from an industrial hydraulic lift table that has a 2,000 lb lift capacity. It has a 2 ft wide table surface like the Handy Lift, and a Handy Industries wheel clamp. It has a very high 42" maximum table height, and can be set at any elevation from 7" to 42" with the push of a button. It has casters welded to the end to enable you to roll it anywhere, and casters on the side to enable you to move it side to side. I have two of these I built and don't need them both. Just $700 compared to a Handy pneumatic table that only has about five height settings and costs over $1,200. Ramp and dolly available separately through Handy Industries. I will help load it because it is pretty heavy, but it is on wheels, so it can be rolled into place on your shop floor after unloading with a ramp. Call Dan at two seven zero, 9 nine three 69 seven 6 weekends or after 6pm through the week. Let's block ads! (Why?)